How To Change Door Lock Fasteners On A Wooden Entryway

When you are living in a neighborhood where there are a lot of break-ins, you should think about having your doors changed with new ones. These types of incidents are becoming more frequent as the years go by. There are many ways that people can protect themselves and their possessions when there is a break-in. Having your doors changed is one way that everyone can do their part to decrease the chance of their home being broken into. This article will show you how to do this.

There are many reasons that you should have your doors changed when you want to change locks on them. You should only change the old key if you can’t find a match for the new key. If the old door lock isn’t working correctly then perhaps you should make some small repairs or even replace it altogether to improve your house security. If you find some wear and tear in the locks then you should get new replacements of the rusty locks.

The key that you use to change door locks should match the new key. You should never use a different key for the purpose than you used to put it on your keys. Old door locks provide maximum protection, so you should replace them with new ones. They are available at most hardware stores and you can also purchase them online. These locks can be installed by using a professional, but you can do the installation yourself if you know what you are doing.

To change door locks, you should start by removing the bolt that holds the lock in place from the frame. Next, remove the keyhole from the top and turn the assembly around until you are able to unscrew it from the frame. You may have to drill a few holes to allow a bolt to be fed through the turn assembly.

Most modern doors will not require any additional drilling. older doors, however, will require a few more holes to allow the lock to be unbolted from its original position. Drill these holes and slip in a new key, being careful to ensure the bolt on the bottom of the turn assembly is out. You should reassemble the lock and re-screw the keyhole before turning the screw clockwise again to secure the turn assembly in place. Make sure the new locks have enough space to turn on and off because in an emergency you need maximum security for your home.

Drill the new holes and insert a screw cap over each hole and tighten each bolt, being careful to not lose the headgear. Install the new holes and screw the plate onto the turn assembly. Put new strike plates over the bolt and tighten them as well. Tighten and replace the turn assembly until it is locked into place. Run a freshwater supply into the house and turn on the water. Turn on the electricity, open the door, and test it to make sure everything is working correctly.

Leave a Reply

Your email address will not be published. Required fields are marked *